wholesaletrade

Ways Of Set Computer Speakers Bring High Quanlity Sounds

When consumers choose a good computer speakers for its own, the next task is to carry out positioning of the speakers, installation and commissioning and a series of work. As the home theater speaker system installation, positioning and debugging, and other aspects of a strictly regulated, which means that the user only to comply with these specifications for installation and commissioning of the speaker to get good sound. In fact, the magazine in the past, this issue has touched home theater speaker Yixiexiangguan installation steps and Diaoshifangfa, but some may Zhi against Mougeteshu the Huanjingjinhang explain and not necessarily for the rest of the family environment. Therefore, in this month's special report, we will be for general family environment on the speaker for the installation and commissioning - times introduced in hopes of giving consumers computer components guide.More information you can know by tradetang.com.

Front of the channel by the two main speakers and a center speaker component, referred to as LCR channels. These three speakers are responsible for most of the voice software. Therefore, when installation is very important. According to THX example, LCR speaker is the best way to install three speakers installed on the same height, and with the listener's ear height when seated flush, so as to get the best sound and voice dialogue locate the right people . However, most consumers do not necessarily have a family computer usb hubs environment for such conditions.

Current market selling surround sound speakers and a dipole type of radiation traditional direct radiation type speaker. For the current 7.1-channel AV systems, you need to use computer memory card surround speakers. An case, you can configure four dipole radiation type speaker or four direct radiation enclosure, or side of the channel with dipole-type speakers, rear channel is direct radiation enclosure. Installation of these speakers have some specific requirements. For example, the direct radiation speaker and as the front LCR channels will point to the listening position the radiation for the dipole-type speakers need to be speaker of the "zero zone" pointing to the listening position.

Subwoofer is primarily used to make up for shortage of the main computer earphones designed for low-frequency limit, while it can also serve to increase the role of low-frequency energy. Therefore, consumers must be configured before use AV amplifier low-frequency crossover point. Crossover in the set should be based on your choice of speakers be set. For example, the choice is M & K, Atlanta, etc. are THX certified home theater speaker, then the crossover point can be all set to 80Hz. As for the other speakers, you must be based on the low-frequency response of each speaker to set the crossover point for each channel. Crossover Frequency setting is completed, you can be on subwoofer positioning. Then the subwoofer placed in the room which place more suitable? As low frequency below 80Hz is almost non-directional, so in theory, free to place the subwoofer anywhere in the room.